If the nails do not stay put hammer additional 2 inch nails beside the original nail to.
Patching hardboard siding.
If water seeps into joints between hardboard panels or penetrates through small holes it will cause the panels to deteriorate.
Now when somebody googles what i tried they 39 ll at least get my post and know they 39 re not the only one.
Scrub the brush around the hole to dislodge dirt and debris.
Level the wood.
Step 3 sand the area.
Hammer down loose nails.
The best filler for your siding is a two part epoxy product that cures to a rock hard consistency.
Because cement is the largest component of the siding it s hard on saw blades.
The fiber cement siding is nailed in place so the rows are consistent with the rest of the wall.
After installation you caulk and paint it like any other siding.
When the new siding has been painted two coats of top quality acrylic latex over a primer the repair is hard to spot.
Scoop a golf ball sized.
How to repair masonite wood siding 1.
1 scrape all loose paint from around the area to be repaired using a paint scraper or putty.
Step 2 apply filler compound.
Use a 4 foot level to check and then hammer in another nail.
Slightly overlap the putty onto the surrounding hardboard by 1.
The wood grain pattern on the fiber cement siding is often a perfect match with existing hardboard although it s not as good a match with real rough sawn wood.
Scrub the surface of the rot or.
How to repair masonite siding with putty step 1.
Immediately fill holes with a flexible all purpose filler such as pre mixed bridging and patching compound following label directions.
Step 4 paint the siding.
How to repair hardboard siding.
Pack wood putty into the hole using a trowel.
The siding panels nearest to the.
Sand the area smooth and then paint it to match the rest of the siding.
If you re replacing more than one board in a run simply hammer a nail into the top corner to support it and then move half way down the board.
Be sure the top one goes through both boards.
Then hammer away on the rest of the board.
So if you re cutting much a masonry blade is a great idea.
Step 1 check the siding panels and clean the holes.
Clean the hardboard with a stiff bristle brush.
