And either an organic or modified underlayment depending on whether tiles or shingles are being.
Open cut roof valley.
Many roofers cut the shingles across because they say it s safer.
Roof is 5 12 slope with a couple of valleys.
One nail goes into the top section of the shingle where it covers the valley metal.
An open valley relies on metal flashing for protection.
See our discussion of alternative flashing materials found.
However it is said that provided the rest of the roofing shingles were properly installed and are performing properly open valleys will perform better over time than closed valleys.
The cut edge then is sealed with roof cement.
At flashing wall details.
Can t afford standing seam metal though so it will be mid grade architectural asphalt shingles installed with meticulous detail.
That flashing is left exposed so the roof has visible lines of metal running down the valley.
Open valley shingle installation.
The shingles are then cut out of the valley area opening the surface of the valley lining to water run off and the environment.
With an open valley a strip of metal will be visible on the roof wherever two opposing roof planes meet.
Open valleys may be susceptible to water backup if the cut off shingles are not properly trimmed potentially causing roof leaks.
With a heavy gauge noncorrosive metal lining open valleys are the most durable valley and the most costly.
The rest of the nails go in the nailing strip.
I finish the cut edge with a double bead of roof cement the same as for the open metal valley.
An economical version uses two layers of roll roofing for the lining which should last as long as an asphalt roof.
No one of this affirmat.
A chalk line is then used to strike a line from the top of the valley to the bottom of the valley.
In this video i show you how i do the valleys on a shingle roof.
I want my roof to be as leak proof and long lasting as possible.
The seam where the two planes of roofing meet are aesthetically woven together to form an interlaced design which creates a seam that matches the contours of the roof.
A roof using the open valley style involves placing a v or w shaped piece of metal usually galvanized or sometimes copper in the seam of the valley and then covered with a base sheet such as 30lb.
With sheet metal protecting the lower layer of shingles the shingles on top are cut back to the line right.
Roofing shingles are installed then cut and sealed where they overlap the metal channel.
Some homeowners do not like the look of open valleys while others feel the metal accentuates the roof s shape particularly if copper or painted flashing is used.
From the stepped off main part of the roof run shingles into the valley and cut them square from where the bottom corner intersects with the shingles nailed along the valley line.
When all the shingles are installed to the guide line the cutline is resnapped left.
The metal is usually pre painted to best complement the shingles color blend.
